To Next Page

To Previous Page

1-12

Security Overview

Getting Started with Access Security

2. When you enter the wizard, you have the following options:

• To update a setting, type in a new value, or press [Enter] to keep the

current value.

• To quit the wizard without saving any changes, press [CTRL-C] at any

time.

• To access online Help for any option, press [?].

After you have gone through each setup option, the wizard displays the

summary configuration together with a prompt to save the changes (see

Figure 1-1 on page 1-11 for an example).

3. When the message appears asking if you want to save these changes, you

have the following options:

• To save your changes, press [Enter].

• To cancel any changes without saving, type [n] and then press [Enter].

After pressing [Enter], the wizard exits to the command line prompt.

CLI Wizard: Operating Notes and Restrictions.

■ Once a password has been configured on the switch, you cannot remove

it using the CLI wizard. Passwords can be removed by executing the no

password command directly from the CLI.

■ When you restrict SNMP access to SNMPv3 only, the options SNMPv2

community name and access level will not appear.

■ The wizard displays the first available SNMPv2 community and allows the

user to modify the first community access parameters.

■ The wizard creates a new SNMP community only when no communities

have been configured on the switch.

■ The USB Autorun feature is disabled as soon as an operator or manager

password is set on the switch. Once a password has been set, the USB

autorun option is no longer provided as part of the wizard.

WebAgent: Management Interface Wizard

To use the Management Interface wizard from the WebAgent, follow the steps

below:

1. In the navigation tree, select Security.

2. Click on the Security Wizard. The Welcome window appears.

HP J8698A User Manual

Other manuals for HP J8698A