11-26
Configuring Advanced Threat Protection
Dynamic IP Lockdown
Assuming that DHCP snooping is enabled and that port 5 is untrusted,
dynamic IP lockdown applies the following dynamic VLAN filtering on port 5:
Figure 11-4. Example of Internal Statements used by Dynamic IP Lockdown
Note that the deny any statement is applied only to VLANs for which DHCP
snooping is enabled. The permit any statement is applied only to all other
VLANs.
Enabling Dynamic IP Lockdown
To enable dynamic IP lockdown on all ports or specified ports, enter the ip
source-lockdown command at the global configuration level. Use the no
form of the command to disable dynamic IP lockdown.
Operating Notes
â– Dynamic IP lockdown is enabled at the port configuration level and
applies to all bridged or routed IP packets entering the switch. The only
IP packets that are exempt from dynamic IP lockdown are broadcast
DHCP request packets, which are handled by DHCP snooping.
â– DHCP snooping is a prerequisite for Dynamic IP Lockdown operation.
The following restrictions apply:
• DHCP snooping is required for dynamic IP lockdown to operate. To
enable DHCP snooping, enter the dhcp-snooping command at the
global configuration level.
Syntax: [no] ip source-lockdown <port-list>
Enables dynamic IP lockdown globally on all ports or on
specified ports on the routing switch.
permit 10.0.8.5 001122-334455 vlan 2
permit 10.0.8.7 001122-334477 vlan 2
permit 10.0.10.3 001122-334433 vlan 5
deny any vlan 1-10
permit any
permit 10.0.10.1 001122-110011 vlan 5
To Next Page
Need help?
General
