9-6
Configuring Secure Socket Layer (SSL)
Configuring the Switch for SSL Operation
Configuring the Switch for SSL
Operation
1. Assigning a Local Login (Operator) and
Enabling (Manager) Password
At a minimum, HP recommends that you always assign at least a Manager
password to the switch. Otherwise, under some circumstances, anyone with
Telnet, web, or serial port access could modify the switch’s configuration.
Using the WebAgent To Configure Local Passwords. You can configure
both the Operator and Manager password in the WebAgent. To access the
WebAgent, refer to the chapter titled “Using the HP WebAgent” in the Basic
Operation Guide for your switch.
2. Generating the Switch’s Server Host Certificate
You must generate a server certificate on the switch before enabling SSL. The
switch uses this server certificate, along with a dynamically generated session
key pair to negotiate an encryption method and session with a browser trying
to connect via SSL to the switch. (The session key pair mentioned above is
not visible on the switch. It is a temporary, internally generated pair used for
a particular switch/client session, and then discarded.)
SSL-Related CLI Commands in This Section Page
web-management ssl page 9-16
show config page 9-16
show crypto host-cert page 9-10
crypto key
generate cert rsa bits <1024 | 2048> page 9-8
zeroize cert page 9-8
crypto host-cert
generate self-signed [arg-list] page 9-8
zeroize page 9-8
To Next Page
Loading...
Need help?
General
