To Next Page

To Previous Page

13-57

Configuring Port-Based and User-Based Access Control (802.1X)

Displaying 802.1X Configuration, Statistics, and Counters

Figure 13-11.Example of show port-access authenticator Command

The information displayed with the show port-access authenticator command

for individual (config | statistics | session-counters | vlan | clients) options is

described below.

HP Switch(config)# show port-access authenticator

Port Access Authenticator Status

Port-access authenticator activated [No] : Yes

Allow RADIUS-assigned dynamic (GVRP) VLANs [No] : Yes

Auth Unauth Untagged Tagged % In RADIUS Cntrl

Port Clients Clients VLAN VLANs Port COS Limit ACL Dir

---- ------- -------- -------- ------ --------- ----------- ------ -----

1 1 1 4006 Yes 77777777 No Yes both

2 2 0 MACbased No No No Yes both

3 4 0 1 Yes No No No both

...

Syntax: show port-access authenticator config [port-list]

Displays 802.1X port-access authenticator configuration

settings, including:

• Whether port-access authentication is enabled

• Whether RADIUS-assigned dynamic VLANs are supported

• 802.1X configuration of ports that are enabled as 802.1X

authenticators (For a description of each setting, refer to

the syntax descriptions in “2. Reconfigure Settings for

Port-Access” on page 13-21. Use the show running

command to view the current client-limit configuration

available for switches.)

You can display 802.1X port-access authenticator

configuration for all switch ports or specified ports.

802.1X configuration information for ports that are not

enabled as 802.1X authenticators is not displayed.

HP J8698A User Manual

Other manuals for HP J8698A