Making Connections
Connecting External Components
Reference Guide 75
In Windows 98, you need to install the Direct Cable Connection software first:
1. From Control Panel, click Add/Remove Programs.
2. Click Windows Setup, Communications, and select Direct Cable Connection.
See the Windows online help for instructions about how to use Direct Cable Connection
or Wireless Link.
To use an external monitor
You can connect your computer to an external monitor and then use either display—or
both displays at once.
To connect an external monitor
1. Click Start, Shut Down, Shut down, OK.
2. Connect the monitor cable from the monitor to the VGA port on the rear of the
computer or on the optional port replicator.
3. Connect the monitor to a power source and turn it on.
4. Slide the power switch to turn on the computer.
To switch the display to the external monitor
= Close the computer lid.
OR
= Press Fn+F5 (or Left Ctrl+Left Alt+F5 on an external keyboard) to cycle through the
display options: notebook display, external monitor, both.
To adjust monitor resolution
1. Click Start, Settings, Control Panel, Display.
2. On the Settings tab, adjust the Screen area.
To use dual display mode (Windows 98 and Windows ME)
You can extend the desktop by connecting an external monitor to your notebook.
Dual display mode requires that your computer display be set as shown in the table below.
Click Start, Settings, Control Panel, Display, Settings tab to adjust these settings.
To Next Page
Loading...
Need help?
General