HP ProCurve 1810G User Manual

9-2
Diagnostics
Log Configuration
■ Click Apply to ping the specified host. The output includes the following data:
• IP Address—The IP address of the device that was pinged.
• Sequence—The Internet Control Message Protocol (ICMP) number of the packet, starting
from 0.
• Time—The ping reply status.
• Transmitted Packets—The number of packets sent.
• Received Packets—Number of packets received.
• Min/Max/Avg RTT—Specifies the Minimum, Maximum, Average Round Trip Time (msec).
Log Configuration
HP ProCurve 1810G switch software supports logging system messages to the Log file or forwarding
messages over the network using the Syslog protocol. Syslog messages can be captured by a designated
host on the network that is running a Syslog daemon.
Note The log file is limited to 100 entries. The most recent 100 defects are displayed; index numbering may
not be 1-100. See your syslog entries to view more than 100 events.
To display the Log Configuration page, click Diagnostics > Log Configuration in the navigation pane.
Figure 9-2. Log Configuration Pages

HP ProCurve 1810G Specifications

General

Brand	HP
Model	ProCurve 1810G
Category	Switch
Language	English