RADIUS Authentication and Accounting
Messages Related to RADIUS Operation
1. Delete 10.10.10.003 from the list. This opens the third (lowest) position in
the list.
2. Delete 10.10.10.001 from the list. This opens the first (highest) position in
the list.
3. Re-enter 10.10.10.003. Because the switch places a newly entered address
in the highest-available position, this address becomes first in the list.
4. Re-enter 10.10.10.001. Because the only position open is the third position,
this address becomes last in the list.
Removes the “003” and “001” addresses from
the RADIUS server list.
Inserts the “003” address in the first position in
the RADIUS server list, and inserts the “001”
address in the last position in the list.
iShows the new order n which the switch
searches for a RADIUS server.
Figure 6-29. Example of New RADIUS Server Search Order
Messages Related to RADIUS Operation
Message Meaning
Can’t reach RADIUS server < x.x.x.x >. A designated RADIUS server is not responding to an
authentication request. Try pinging the server to determine
whether it is accessible to the switch. If the server is
accessible, then verify that the switch is using the correct
encryption key and that the server is correctly configured
to receive an authentication request from the switch.
6-61
To Next Page
Loading...
Need help?
General