Getting Started
Need Only a Quick Start?
Figure 1-5. Example of How To Display Help for a CLI Command
â– If you need information on specific features in the web browser interface
use the online help available for the web browser interface. For more
information on web browser Help options, refer to the Management and
Configuration Guide for your switch.
â– If you need further information on Hewlett-Packard switch technology,
visit the ProCurve Networking web site at:
http://www.procurve.com
Need Only a Quick Start?
IP Addressing. If you just want to give the switch an IP address so that it
can communicate on your network, or if you are not using VLANs, HP
recommends that you use the Switch Setup screen to quickly configure IP
addressing. To do so, do one of the following:
â– Enter setup at the CLI Manager level prompt.
ProCurve# setup
â– In the Main Menu of the Menu interface, select
8. Run Setup
For more on using the Switch Setup screen, refer to the Installation and
Getting Started Guide you received with the switch.
1-8
To Next Page
Loading...
Need help?
General