Using Authorized IP Managers
Defining Authorized Management Stations
5. [Enter] [S] (for Save
i
3.
ll
l
2. i
4.
li
Press , then ) to configure the
IP Author zed Manager entry.
Use the default mask to allow access by one
management device, or edit the mask to a ow
access by a b ock of management devices. See
“Building IP Masks” on page 12-9.
Enter an Author zed Manager IP address here.
Use the Space bar to select Manager or Operator
access.
App es only to access through Telnet, SNMPv1,
and SNMPv2c. Refer to the note on page 12-3.
Figure 12-2. Example of How To Add an Authorized Manager Entry (Continued)
Editing or Deleting an Authorized Manager Entry. Go to the IP Manag-
ers List screen (figure 12-1), highlight the desired entry, and press [E] (for Edit)
or
[D] (for Delete).
CLI: Viewing and Configuring Authorized IP Managers
Authorized IP Managers Commands Used in This Section
Command Page
show ip authorized-managers below
ip authorized-managers 12-7
<ip-address> 12-8
mask <mask-bits> 12-8
<operator | manager>
Listing the Switch’s Current Authorized IP Manager(s)
Use the show ip authorized-managers command to list IP stations authorized to
access the switch. For example:
12-6
To Next Page
Loading...
Need help?
General