To Next PageTo Next PageTo Previous PageTo Previous Page
Loading...
Need help?Do you have a question about the HP ProCurve Switch 5406zl and is the answer not in the manual?
General| Model | HP ProCurve Switch 5406zl |
|---|---|
| Layer | Layer 3 |
| Jumbo Frame Support | Yes, up to 9220 bytes |
| Management | Web, CLI, SNMP |
| Redundancy | Redundant power supply supported |
| VLAN Support | Yes (up to 4096 VLANs) |
| Ports | 6 open slots, supports up to 144 Gigabit Ethernet ports or 48 10-Gigabit Ethernet ports |
| Dimensions | 17.5 x 12.2 x 10.5 in (44.5 x 31 x 26.7 cm) |
Describes the Services Module, its platform, and integration with HP ProCurve switch architecture.
Details the process and precautions for installing the Services Module into a switch chassis.
Provides step-by-step instructions for physically installing the Services Module into a switch.
Explains how to confirm successful module installation using LEDs and self-test results.
Lists the operating and non-operating environmental parameters for the Services Module.
Outlines the initial steps and CLI usage for configuring the Services Module after installation.
Guides on checking and updating the switch software compatible with the Services Module.
Explains how to update the software images for the Services Module, including different image types.
Details the process for installing or updating the Service Operating System on the Services Module.
Describes how to download product software or applications onto the Services Module.
Outlines the steps to install a downloaded product image onto the Services Module's hard disk.
Explains how to activate a product on the Services Module using a license key.
Discusses the possibility and process of downloading multiple products, and their limitations.
Provides information on how to obtain technical support and assistance from HP.
States compliance with FCC Class A limits for digital devices in commercial environments.
Declares compliance with Class A Canadian EMC requirements for the product.
Confirms compliance with Australia/New Zealand EMC Class A requirements.
States compliance with Japan VCCI Class A requirements for the device.
Provides regulatory information for Class A devices in Korea.
Details regulatory compliance for Class A information products in Taiwan.
Instructs users on the proper disposal of the product as WEEE in the European Union.
Describes the function of front panel buttons and the meaning of various LEDs on the Services Module.
Details the two internal Ethernet ports and how they are named by the switch.
Explains the importance of serial numbers for warranty and where to find them.
Illustrates the location of Test, Fault, and Module Status LEDs on compatible switch models.
Recommends module shutdown before replacement and discusses hot-swapping procedures.
Provides step-by-step instructions for replacing the disk drive within the Services Module.
Details the procedure for replacing the flash card within the Services Module.
Guides on checking and updating the switch software compatible with the Services Module.
Explains the two methods (FTP, USB) for updating the Service Operating System on the module.
Describes the process of updating the CF Service OS using a USB flash drive.
Explains the process of obtaining and installing a product activation license key.
Details the steps to uninstall a license and obtain a new registration ID.
Describes how to view the history of license transactions on the My ProCurve portal.
Explains how to export license summary data to a spreadsheet or text file.
