NOTE:
The stor age server can be deployed without a monitor, keyboard, and
mouse. These ports are available and supported by the storage server,
if used.
Method 1: Remote browser (using host name)
The storage server ships with DHCP enabled on the network port. If the
system is placed on a D HCP-enabled net work and the serial number of
the device is known, it can be accessed through a client running Internet
Explorer 5.5 (or later) on that network, using the 3202 port of the device.
Requirements to run the WebUI configuration application are:
• Windows-based PC loaded with Internet Explorer 5.5 (or later) on
thesamesegmentasthestorageserver
• DHCP-enabled network
• Serial number of the storage server
1. Connect the Ethernet cable to the net work port of the storage server
and the corresponding network segment.
2. Go to the storage server and power it on. It takes several minutes
before the storage server is accessible on the network.
NOTE:
The storage server responds when the storage server
operating system has started.
3. Op en Internet Explorer on the PC. Enter https://,theserialnumber
of the storage server followed by a hyphen (-) , and then:3202.Press
Enter.
Example: https://D4059ABC3433-:3202
NOTE:
Substitute the server name for the serial number if a server
name was previously set.
4. Log into the WebUI. This launches the WebUI configuration
application (Rapid Startup) on the target HP ProLiant storage server,
as shown in Figure 1.
24
Storage server startup
To Next Page
Loading...
Need help?
General
