Power cords
Thepowercordsetmustmeettherequirementsforuseinthecountrywhere
the product was purchased. If the product is to be used in another country,
purchase a power cord that is approved for use in that country .
The power cord must be rated for the product and for the voltage and
current marked on the product electrical rating label. The voltage and
current rating of the cord should be greater than the voltage and current
rating marked on the product. In addition, the diameter of the wire must be
aminimumof1.00mm
2
or 18 AWG, and the length of the cord must be
between 1.8 m (6 ft) and 3.6 m (12 ft). If you have questions about the
type of power cord to use, contact an HP authorized service provider.
NOTE:
Route power cords so that they will not be walked on and cannot be
pinched by items placed upon or against them. Pay par ticular attention
to the plug, electrical outlet, and the point where the cords exit from the
product.
Japanese power cord notice
Electrostatic discharge
To prevent damage to the system, be aware of the precautions you need to
follow when setting up the system or handling parts. A discharge of static
electricity from a finger or other conductor may damage system boards
or other static-sensitive devices. This type of d amage may reduce the life
expectancy of the device.
Preventing electrostatic discharge
To prevent electrostatic damage, observe the following precautions:
• Avoid hand contact by transporting and storing products in
static-safe containers.
• Keep electrostatic-sensitive parts in their containers u ntil they arrive
at static-free workstations.
HPProLiantStorageServeruserguide
55
To Next Page
Loading...
Need help?
General
