• Place parts on a g rounded sur face before removing them from
their containers.
• Avoid touching pins, leads, or circuitry.
• Always be properly grounded when touching a static-sensitive
component or assembly.
Grounding m etho d s
There are several methods for grounding. Use one or more of the following
methods when handling or installing electrostatic-sensitive parts:
• Useawriststrapconnectedbyagroundcordtoagrounded
workstation or computer chassis. Wrist straps are flexible straps
with a minimum of 1 megohm ± 10 percent resistance in the
ground cords. To provide proper grounding, wear the strap snug
against the skin.
• Useheelstraps,toestraps,orbootstrapsatstandingworkstations.
Wear the straps on both feet when standing on conductive floors
or dissipati ng floor mats.
• Use conductive field service tools.
• Use a portable field service kit with a folding static-dissipating
work mat.
If you do not have any of the suggested equipment for proper grounding,
have an authorized reseller install the part.
NOTE:
For more information on static electricity, or for assistance with product
installation, contact your authorized reseller.
Waste Electrical and Electronic Equipment (WEEE)
directive
Czechoslovakian notice
Likvidace zařízení soukromými domácími uživateli v Evropské unii
Tento symbol na produktu nebo balení o značuje výrobek, který
nesmí být vyhozen spolu s ostatním domácím odpadem. Povinností
uživatele je p ředat takto označený odpad na předem určené sběrné
56
Regulatory compliance and safety
To Next Page
Loading...
Need help?
General
