EasyManuals Logo
Home>HP>Tablet>Split 13 x 2 PC

HP Split 13 x 2 PC User Manual

HP Split 13 x 2 PC
102 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #48 background imageLoading...
Page #48 background image
micro Solid-state drive (mSSD)
Description Spare part number
128-GB mSSD 737218-001
64-GB mSSD 737217-001
Before removing the solid-state drive, follow these steps:
1. Turn off the tablet. If you are unsure whether the tablet is off or in Hibernation, turn the tablet on,
and then shut it down through the operating system.
2. Disconnect the power from the tablet by unplugging the power cord from the tablet.
3. Disconnect all external devices from the tablet.
4. Remove the back cover (see
Back cover on page 34).
5. Remove the tablet battery (see
Tablet battery on page 36).
Remove the solid-state drive:
1. Remove the Phillips PM2.0×3.0 screw (1) that secures the solid-state drive to the system board.
(The solid-state drive tilts up.)
2. Remove the solid-state drive (2) by pulling the drive away from the slot at an angle.
40 Chapter 4 Removal and replacement preliminary requirements

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP Split 13 x 2 PC and is the answer not in the manual?

HP Split 13 x 2 PC Specifications

General IconGeneral
BrandHP
ModelSplit 13 x 2 PC
CategoryTablet
LanguageEnglish

Related product manuals