EasyManuals Logo
Home>Huawei>Network Router>AR1200-S

Huawei AR1200-S User Manual

Huawei AR1200-S
308 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #107 background imageLoading...
Page #107 background image
l Set the rate limit in pps for traffic suppression.
– Run the broadcast-suppression packets packets-per-second command to set the rate
limit in pps for broadcast traffic.
– Run the multicast-suppression packets packets-per-second command to set the rate
limit in pps for multicast traffic.
– Run the unicast-suppression packets packets-per-second command to set the rate limit
in pps for unknown unicast traffic.
NOTE
The SRU on the AR1200-S does not support the rate limit in pps. The rate limit in pps can be set on
LAN-side GE interfaces and LPU Ethernet interfaces.
----End
4.3.3 Checking the Configuration
This section describes how to check the configuration of traffic suppression.
Prerequisites
The traffic suppression configurations are complete.
Procedure
l Run the display flow-suppression interface interface-type interface-number command to
check the traffic suppression configuration.
----End
Example
Run the display flow-suppression interface interface-type interface-number command to
check the traffic suppression configuration on the specified interface.
<AR1200-S> display flow-suppression interface ethernet 2/0/1
storm type rate mode set rate value
-------------------------------------------------------------------------------
unknown-unicast pps packets: 1260(packets per second)
multicast pps packets: 2520(packets per second)
broadcast pps packets: 1260(packets per second)
-------------------------------------------------------------------------------
4.4 Configuration Examples
This section provides traffic suppression configuration examples.
4.4.1 Example for Setting the CIR Value for Traffic Suppression
This section describes how to set the CIR value for traffic suppression.
Networking Requirements
As shown in Figure 4-1, RouterA is connected to a Layer 2 network and a Layer 3 router. To
limit the number of broadcast, multicast, or unknown unicast packets forwarded on the Layer 2
network, you can set the rate limit in bit/s on Ethernet 0/0/0.
Huawei AR1200-S Series Enterprise Routers
Configuration Guide - Security 4 Traffic Suppression Configuration
Issue 02 (2012-03-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
93

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Huawei AR1200-S and is the answer not in the manual?

Huawei AR1200-S Specifications

General IconGeneral
BrandHuawei
ModelAR1200-S
CategoryNetwork Router
LanguageEnglish

Related product manuals