Procedure
Step 1 Configure the URPF check mode on the interface.
<Huawei> system-view
[Huawei] sysname RouterA
[RouterA] interface gigabitethernet 1/0/0
[RouterA-GigabitEthernet1/0/0] urpf strict allow-default-route
[RouterA] interface gigabitethernet 2/0/0
[RouterA-GigabitEthernet2/0/0] urpf strict allow-default-route
Step 2 Verify the configuration.
Run the display this command on GE1/0/0 to view the URPF configuration.
[RouterA-GigabitEthernet1/0/0] display this
#
interface GigabitEthernet 1/0/0
urpf strict allow-default-route
#
return
Run the display this command on GE2/0/0 to view the URPF configuration.
[RouterA-GigabitEthernet2/0/0] display this
#
interface GigabitEthernet 2/0/0
urpf strict allow-default-route
#
return
----End
Configuration Files
#
sysname RouterA
#
interface GigabitEthernet 1/0/0
urpf strict allow-default-route
#
interface GigabitEthernet 2/0/0
urpf strict allow-default-route
#
return
Huawei AR1200-S Series Enterprise Routers
Configuration Guide - Security 8 IP Address Anti-spoofing Configuration
Issue 02 (2012-03-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
167
To Next Page
Loading...
Need help?
General
