Humminbird ONIX Opeartion Manual

163
SONAR SETUP
T
he available sonar views and menus on the control head are determined by the connected transducer and the selected transducer
s
ource. The selected transducer must be pinging to enable the views.
When you connect a transducer to a black box sonar or to the ONIX control head, the transducer will be detected in the network
automatically. The best sonar source will be chosen and start pinging automatically.
To manually select a sonar source, see Installation Information: Set up your Humminbird Network.
Transducer Settings: To review transducer settings, including sonar frequencies, depth offset, and maximum depth, see
Installation Information: Set up or Change Transducer Settings. Also, visit our Web site at humminbird.com to download the
Transducer Setup Guide and review troubleshooting options.
Sonar Settings: You can also change the water type, adjust the noise filter, and select transducer beams. The main sonar
settings are displayed in the Sonar tab in the Settings tool (Home > Settings > Sonar). If an accessory transducer is added to
the configuration (such as a 360 Imaging transducer or an Airmar CHIRP transducer), the related menu options will be added
to the menu system. See Installation Information: Set up or Change Transducer Settings.
NOTE: Visit our Web site at humminbird.com for the latest compatible transducers and accessories for your control head.
Sonar Setup

Humminbird ONIX Specifications

General

Brand	Humminbird
Model	ONIX
Category	GPS
Language	English