MOUNTING THE CONTROLLER TO WALL
Wall Mount for Plastic and Metal Cabinet
All necessary mounting hardware is included with your controller and
should be suitable for most installations.
Tools required:
• Long drill bit and extension Philips screwdriver or bit (for use with long
extension) – magnetic recommended Wire strippers
NOTE: This controller must be installed in compliance
with local electrical codes.
Location Requirement: A) A switch or circuit-breaker shall be included in
building installations; B) the switch or breaker shall be in close proximity
to the controller and within easy reach of the operator; C) the switch or
breaker shall be marked as the disconnecting device for the controller;
D) the switch or circuit breaker used must comply with IEC 60947-1 and
IEC 60947-3.
Select a location for your controller that can be easily accessible, has
a at wall surface, and is within close proximity to a 120VAC(10A) or
230/240VAC(5A) power source.
In outdoor installations, avoid direct exposure to sprinkler spray. Shaded or
partially shaded areas are preferable to prolonged direct sunlight.
1. Using the enclosed mounting template, mark the mounting hole
locations on the wall. It should be mounted at eye level if possible.
2. Drill a ¼" (6 mm) hole at each mark.
3. Install screw anchors into holes if attaching the controller to drywall,
masonry, or plaster walls.
4. Open the controller and inner door. The inner door will swing out of
the way to provide full access to the controller mounting holes.
5. Holding the controller cabinet, line up the holes in the cabinet with
the wall anchors or pilot holes.
6. Drive a screw through each hole and secure snugly but do not
over tighten.
7.
OPTIONAL:
Locate the positioning hanger in the upper center of the
controller (A). Install one screw (B) in this hanger position and hang
the controller from the keyhole slot. Place a level on the top of the
controller cabinet and level. Locate and drive a screw in each of the
remaining screw holes (C), and secure snuggly but do not over tighten
the screws.
C
B
A
4
To Next Page
Loading...
Need help?
General
