7
Sensor Wire to SEN
Mini-Clik
®
Weather Sensor
Sensor Wire to SEN
A Hunter Mini-Clik
®
rain sensor or other type of micro-switch weather
sensor may be connected to the Pro-C. The purpose of a rain sensor is
to stop watering when precipitation is sufficient.
1. Route the wires from the rain sensor up through the same conduit
used for valve wiring.
2. Remove the metal jumper plate from the two SEN terminals.
3. Connect one wire to the SEN
terminal and one to the other
SEN terminal.
4. When the weather sensor has
deactivated automatic watering,
OFF and sensor will appear on the
display
Manually Bypassing the Weather Sensor
If the rain sensor is interrupting irrigation you can bypass it by using
the bypass switch on he front of the controller. Slide the switch to the
RAIN SENSOR
BYPASS
ACTIVE
SYSTEM
SENSOR
CONNECTING A WEATHER SENSOR (not included) ..........................................................
NOTE: If the rain sensor switch is left in the ACTIVE
position and no sensor is connected and the jumper
has been removed, the display will read SEN OFF
and no irrigation will occur. To eliminate this
problem when no sensor is connected, leave the
switch in the BYPASS position or install a short
jumper wire between the sensor terminals.
Bypass switch
SENSOR BYPASS position to disable the rain sensor from the system
to allow for the controller operation. You can also bypass the weather
sensor for manual operation by using the MANUAL - SINGLE STATION
function.
To Next Page
Loading...
Need help?
General
