Use the ▼ button to select point B. The ► cursor will be displayed next to
point B. To reset reference point B, press and hold the + button, the date
will change to the current date and the gallons will be set back to 0.
NOTE: The Flow Totalizer feature will not be reset if an
Erase All is performed. This ensures that the ow data
will not be lost during a reset of the controller.
Solar Sync Delay
I-Core with built in Solar Sync has the ability to delay the automatic, daily
update of the seasonal adjustment value from Solar Sync for up to 99 days.
This option may be an advantage to users who do not want the program
run times to be adjusted by Solar Sync until after a set seeding or over
watering period. The Solar Sync Delay function allows the controller to
operate with a manually set seasonal adjustment value during the delay
period so that programs assigned to the Solar Sync Seasonal Adjustment
(see Seasonal Adjustment setting on pg. 17) will use this seasonal
adjustment value until the delay period is over. Once the delay period is
over, the programs assigned to Solar Sync will be adjusted based on the
daily update from the Solar Sync weather data.
1. Turn the dial to the ADVANCED FEATURES dial position.
2. Use the ▲ and ▼ buttons to scroll to the Solar Sync Delay position.
Press the + button to enter.
3. Use the + and – buttons to set number of days of delay. The default
setting is 0 (no delay)
4. Use the ▲ and ▼ buttons to scroll to the Seasonal Adjust During
Delay position. Use the + and – buttons to modify the Seasonal Adjust
during delay (if desired) from the default setting
of 100%.
LCD Adjust
The LCD Adjust feature allows you to increase or decrease the contrast of
the display. This is helpful to make the display more visible in varying light
conditions. You may adjust the contrast of the screen until you are able to
read it effectively.
1. Turn the dial to the ADVANCED FEATURES position. Use the ▲ and
▼ buttons to select LCD Adjust and use the + button to enter.
2. Press the + button to increase the contrast or press the – button to
decrease the contrast until your desired contrast level is achieved.
Flow Totalizer
The Flow Totalizer feature provides a running total of all the gallons or liters
of water used. This is an accumulation of automatic programs, manuals,
remote starts, and any other water that triggers the ow meter, including
leaks in the system. Within the Flow Totalizer screen, you will be given two
start points or references from which the ow calculations will be recorded.
These reference points will be indicated as point A and point B. You may
reset either reference point at any time. This is helpful if you would like
to keep track of the gallons for the year and also for the month. At the
beginning of the year you may reset point A, and the controller will start
recording from that point in time. At the end of each month, record the
total gallons used for point B and simply reset the reference point on B to
start recording the gallons for a new month.
Turn the dial to the ADVANCED FEATURES position. Use the ▲ and ▼
buttons to select Flow Totalizer and use the + button to enter.
The ► cursor will be pointing to A when you initialize the Flow Totalizing
screen. It will show the date of when the point of reference was started and
also the running total of the gallons of water.
If you would like to reset this reference point, press and hold the + button
while the ► cursor is pointing to A. The date will change to the current
date, and the gallons will be set back to 0.
ADVANCED FEATURES (CONTINUED)
26
To Next Page
Loading...
Need help?
General
