22
Programable Sensor Override
The Pro-C allows the user to program the controller so that the sensor
disables watering on only desired stations. For example, patio gardens
that have pots under overhangs and roofs may not receive water when it
rains and will continue to need to be watered during periods of rain. To
program sensor override:
1. Turn the dial to the RUN position.
2. Press and hold the
button down while
turning the dial to START TIMES position.
3. Release the
button. The display will show
the station number, ON, and the
icon, will be
flashing.
4. Press the
or button to enable or disable
the sensor for the station shown.
ON = Sensor enabled (will suspend irrigation)
OFF = Sensor disabled (will allow watering)
5. Use the
or buttons to scroll to the next
station that you would like to program the
sensor override.
NOTE: The controller default is for the sensor to
disable watering on all zones when rain occurs.
When the Pro-C receives an input from the sensor
to disable watering, the display will indicate those
stations that have been programmed to override
the sensor. A station that is running in the sensor
override mode will flash
the and icons
alternately.
Total Run Time Calculator
The Pro-C keeps a running total of each program’s station run times.
This feature provides a quick way to determine how long each program
will water.
1. While in the Set Station Run Time mode use the
button to advance
to the highest station position.
2. Press the
button once to review the total of all run times
programmed.
3. Use the
button to review additional programs.
Test Program
The Pro-C allows the user a simplified method for running a test
program. This feature operates each station in numerical sequence,
from the lowest to the highest. You can start with any station. This is a
great feature to check the operation of your irrigation system.
To initiate the test program:
1. Press and hold the
button. The station number will be flashing.
2. Press the
or button to scroll to the station you would like the
test program to start with. Use the
and button to set a run
time of up to 15 minutes. The run tim e needs to be entered only
once.
3. After a 2 second pause, the test program will begin.
RUN
HIDDEN FEATURES (continued) ............................................................................................
To Next Page
Loading...
Need help?
General
