12 SERVICE WORK ON THE CHASSIS
61
F00281-11
–
Mount and tighten screw
8
.
Guideline
Screw, top
steering stem
M8 17 Nm (12.5 lbf ft)
Loctite
®
243™
K00604-10
–
Tighten screws
9
.
Guideline
Screw, top triple
clamp
M8 17 Nm (12.5 lbf ft)
S02106-12
–
Position the brake caliper, and mount and tighten screws
bk
.
Guideline
Screw, front
brake caliper
M8 25 Nm (18.4 lbf ft)
Loctite
®
243™
– Mount the cable tie(s).
– Position the brake line, wiring harness, and clamp. Mount and
tighten screws
bl
.
Finishing work
– Mount the handlebar cushion.
– Install front fender. ( p. 64)
– Install the front wheel. ( p. 102)
– Install the headlight mask with the headlight. ( p. 113)
– Check that the wiring harness, throttle cables, and brake and
clutch lines can move freely and are routed correctly.
– Check the play of the steering head bearing. ( p. 61)
– Remove the motorcycle from the lift stand. ( p. 55)
– Check the headlight setting. ( p. 116)
12.11 Checking the play of the steering head bearing
Warning
Danger of accidents Incorrect steering head bearing play impairs the handling characteristic and
damages components.
– Correct incorrect steering head bearing play immediately. (Your authorized Husqvarna Motorcycles
workshop will be glad to help.)
To Next Page
Loading...
Need help?
General
