Hypertherm Echion User Manual

Installation
7
148 810770 Operator Manual Echion
Installation
Safety
Buyer responsibilities
The buyer is responsible for these obligations.
 Cooperate with Hypertherm and the Hypertherm original equipment manufacturer(OEM)
regarding the installation of the equipment.
 Obey all setup and first-time start up instructions in this manual.
 Research and obey all local codes, including requirements for waste water disposal.
 Install high-pressure tubing.
 Install water-treatment equipment before the pump is installed.
 Make sure that all utilities are available during installation.
 The site must have sufficient electrical power, air, water, and drain access.
 Make all connections to the pump.
 Fill the hydraulic fluid tank.
 Perform user qualification and training. Refer to User qualification and training on page 23.
WARNING
Read and understand all of the safety guidelines in this manual.
Refer to Safety on page 21 before operating, doing maintenance on, repairing, and installing your
pump.
WARNING
This pump can supply water pressure of up to4,140bar(414,000kPa/60,000psi).
Only use tubing that is rated for this pressure.
WARNING
Use supports for plumbing to prevent damage to plumbing from bending stress and fatigue from
vibration.

Hypertherm Echion Specifications

General

Brand	Hypertherm
Model	Echion
Category	Water Pump
Language	English