Safety
Echion Operator Manual 810770 SC-25
Safety information for operation, maintenance, repair, and installation
DANGER
Before opening the electrical enclosure or doing maintenance or repairs on this equipment, turn
OFF the electrical power and release water pressure and hydraulic pressure from the system.
Use standard lock out-tag out procedures.
Isolate all sources of electrical, mechanical, hydraulic, pneumatic, chemical, thermal, or other
energy with a lockable energy-isolating device that satisfies national and local requirements.
WARNING
Make sure that all connections, fasteners, locking devices, hoses, and fittings are tight before
operation.
WARNING
Make sure that the shaft access cover and all other safety devices are correctly installed before
operating this machine.
WARNING
Do not stand in line with high-pressure fittings when operating this equipment.
If a high-pressure fitting fails, it can cause a stream of water or hydraulic fluid to eject from the
system with force.
WARNING
Do not leave waterjet cutting equipment unattended while it is operating.
WARNING
During operation, keep a restricted-access area clear that is larger than the maximum movement
range of the cutting equipment’s moving parts.
WARNING
Let only approved personnel operate this machinery.
WARNING
Release all high-pressure water before doing work on this equipment.
WARNING
Do not touch a hot surface.
Water leaking from a high-pressure fitting or the bleed-down valve can be hot.
WARNING
Obey all safety requirements and applicable safety laws and regulations.
Obey national and local codes regarding installation, repairs, and maintenance of the electrical
and plumbing systems.
All work that requires opening the electrical enclosure or removing covers or panels from this
equipment must be done only by an approved technician.
It is your responsibility to investigate and obey all local codes.
To Next Page
Loading...
Need help?
General
