Hypertherm HySpeed HT2000LHF User Manual

OPERATION
4-28 HySpeed HT2000LHF Instruction Manual
7
Shield Arc Approx.
Material
Plasma Gas Flow Rate %
Gas (Air) Torch-to-work Initial Torch Voltage Motion
Thickness Preflow Cutflow Pressure Distance Piercing Height Setting Travel Speed Delay Time
(inches) (mm) (Air %) (Air %) (psi) (inches) (mm) (inches) (mm) (volts) (ipm) (mm/min.) (sec)
3/32 2.5 40 20 60 3/32 2.5 3/16 5 120 140 3550
1/8 3 (46.0 (23.1 (275 3/32 2.5 3/16 5 130 100 2550 0.5
1/4 6 SCFH) SCFH) SCFH) 1/8 3 140 35 900
3/8 10 1/8 3 150 15 350
Aluminum
40 amps • Air Plasma / Air Shield
This gas combination gives good cut speed, low dross levels and is very economical.
Notes: Set plasma gas inlet pressure to 90 psi (6.2 bar)
Set shield gas inlet pressure to 90 psi (6.2 bar)
Production cutting above 1/8" (3 mm) not recommended
Above Water Only
020613
Swirl ring
120667
Electrode
020689
Nozzle
020423
Retaining cap
020688
Shield

Hypertherm HySpeed HT2000LHF Specifications

General

Brand	Hypertherm
Model	HySpeed HT2000LHF
Category	Welding System
Language	English