S
spencer58Jul 31, 2025
What to do if the fault LED blinks on my Hypertherm Cutter?
- LLarry SmithJul 31, 2025
A blinking fault LED indicates a major fault with the system. A qualified service technician must service the system.
To Next PageTo Next PageTo Previous PageTo Previous Page
What to do if the fault LED blinks on my Hypertherm Cutter?
A blinking fault LED indicates a major fault with the system. A qualified service technician must service the system.
What to do if the power ON LED is illuminated and the gas pressure LED is illuminated yellow on my Hypertherm Cutter?
First, turn the amperage knob to the gas test position, then unlock the pressure regulator by pulling up on the knob. Turn it to adjust the pressure, and push it down to lock it. Also, verify that the gas supply line is connected to the power supply and the gas is turned on. Finally, inspect the gas supply line for leaks and verify the incoming gas pressure.
What to do if the power ON LED is illuminated and the torch cap LED is illuminated on Hypertherm Cutter?
Turn OFF the power supply and verify that there are consumables installed. If you have just installed the consumables, verify that the consumables are only finger-tight; loosen them 1/8th of a turn and then restart the power supply. If the consumables appear to be installed correctly, the torch may be damaged.
General| Brand | Hypertherm |
|---|---|
| Model | powermax45 |
| Category | Welding System |
| Language | English |
