TORCH SETUP
3-8 powermax
45
Operator Manual
A complete set of shielded consumables is shipped with the T45m machine torch. In addition, an
ohmic-sensing retaining cap is available for use with the T45m shielded consumables. Unshielded
consumables and the T30v (Powermax30) 30 A consumables are also available for use with the
T45m.
How to use the cut charts
The following sections provide illustrations of the consumable sets and cut charts for each set.
Maximum cut speeds are the fastest speeds possible to cut material without regard to cut quality.
Recommended cut speeds are a good starting point for finding the best quality cut (best angle,
least dross, and best cut-surface finish). You will need to adjust the speeds for your application
and your table to obtain the desired cut quality.
Choose the consumables (cut charts)
T45m shielded consumables
220673
Shield
220713
Retaining cap
or
220719
Ohmic-sensing retaining cap
220671
Nozzle
220670
Swirl ring
220669
Electrode
WARNING
INSTANT-ON TORCHES
PLASMA ARC CAN CAUSE INJURY AND BURNS
The plasma arc comes on im me di ate ly when the torch is activated.
Make sure the power is OFF before changing the consumables.
I
O
The cut charts for these consumables are shown on the next pages.
To Next Page
Loading...
Need help?
General
