Release
handle
Release
buttons
Release
handle
A set of blank labels for your blade server comes with the BladeCenter chassis.
When you install the blade server in the BladeCenter chassis, write identifying
information about the blade server on a label. Then place the label on the
BladeCenter chassis bezel. See the documentation for your BladeCenter chassis for
recommended label placement.
Important: Do not place the label on the blade server itself or in any way block
the ventilation holes on the blade server.
Related documentation
Use this information to identify and locate related blade server documentation.
This Installation and User's Guide contains general information about the blade
server, including how to install supported optional devices and how to configure
the blade server. The following documentation is also available:
v Problem Determination and Service Guide
This document contains information to help you solve problems yourself, and it
contains information for service technicians.
v Safety Information
This document contains translated caution and danger statements. Each caution
and danger statement that appears in the documentation has a number that you
can use to locate the corresponding statement in your language in the Safety
Information document.
v Warranty Information
This document contains information about the terms of the warranty.
v Environmental Notices and User Guide
This document contains translated environmental notices.
Chapter 1. Introduction 3
To Next Page
Loading...
Need help?
General