IBM P 615 series User Manual

Table 4. SPCN Error Codes for the CEC (system unit) (continued)
Error Code Description Action/
Possible Failing FRU
1011 8413 Invalid processor VPD System backplane
Location:
U0.1-P1
1011 8414 Invalid processor VPD System backplane
Location:
U0.1-P1
1011 8415 Invalid processor VPD System backplane
Location:
U0.1-P1
1011 8416 Invalid processor VPD System backplane
Location:
U0.1-P1
1011 8423 No processor VPD System backplane
Location:
U0.1-P1
1011 8424 No processor VPD System backplane
Location:
U0.1-P1
1011 8425 No processor VPD System backplane
Location:
U0.1-P1
1011 8426 No processor VPD System backplane
Location:
U0.1-P1
Firmware Error Codes
Attention: If you replace FRUs or perform an action and the problem is still not corrected, go to “MAP
1548: Processor Subsystem Problem Isolation” on page 113 unless otherwise indicated in the tables.
If you replace FRUs and the problem is corrected, go to ″MAP 0410: Repair Checkout″ in the RS/6000
Eserver pSeries Diagnostic Information for Multiple Bus Systems.
Table 5. Firmware Error Codes.
Error Code Description Action/
Possible Failing FRU
20A8 0000 Insufficient information to boot. Verify the IP address.
20A8 0001 The client IP address is already in use by some
other network device.
Change IP address.
20A8 0002 Cannot get gateway IP address. Refer to Table 2 on page 140 using code E174.
20A8 0003 Cannot get system hardware address. Refer to Table 2 on page 140 using code E174.
20A8 0004 Bootup failed. Refer to Table 2 on page 140 using code E175.
20A8 0005 File transmission (TFTP) failed. Check network connection, try again.
20A8 0006 Boot image too large Contact your next level of support for assistance.
20D0 000F Self-test failed on a device, no error and/or
location code information available.
Refer to “Mapping AIX and Physical Location
Codes” on page 28 to see if a location code is
available for the device the error was reported
against.
1. Replace device indicated by the location
code (if available).
2. Go to “MAP 1540: Problem Isolation
Procedures” on page 110
20D0 0010 Self-test failed on a device, cannot locate
package
Contact your service support representative for
assistance.
170 EserverpSeries 615 Service Guide

IBM P 615 series Specifications

General

Brand	IBM
Model	P 615 series
Category	Server
Language	English