IBM P 615 series User Manual

Note: When the system rails are fully extended, the rail safety latches on the slide rails lock into place.
This action prevents the system from being pulled out too far and dropped. The following illustration
shows a system drawer in the service position.
2
3
6
1
4
5
1 Model 6C3 4 Stability Plate
2 19-Inch Rack 5 Front Rack Door
3 Rail Safety Latches 6 System Drawer Release Latch
Returning the Model 6C3 to the Operating Position
To return the Model 6C3 to the operating position, do the following:
1. Press upward on both rail safety latches, located on each rail. See the illustration on page 285 for the
location of the rail safety latches.
2. Push the system drawer back into the rack until both system drawer release latches have locked into
position.
Note:
Ensure that the cables at the rear of the system do not catch or bind as you push the system
drawer back in the rack.
3. If you removed two thumbscrews from the front bezel, replace them.
4. Close the front rack door.
Chapter 9. Removal and Replacement Procedures 285

IBM P 615 series Specifications

General

Brand	IBM
Model	P 615 series
Category	Server
Language	English