IBM P 615 series User Manual

Any identify LED in the system can be flashed when the system is in the failed state with power on by
using the service processor LED Control Menu contained in the “System Information Menu” on page 238.
Any identify LED in the system can also be flashed by using the ″Identify and Attention Indicators″ task in
AIX online diagnostics. The procedure to operate the ″Identify and Attention Indicators″ task in diagnostics
is outlined in the RS/6000 Eserver pSeries Diagnostic Information for Multiple Bus Systems.
If the service processor menus and the AIX diagnostics are not available, the FRU identify LEDs can be
flashed by one of following:
v Boot to the open firmware prompt. See the “System Power Control Menu” on page 235 for instructions
on setting up the boot mode to enable the boot to the open firmware prompt. To display a menu that will
allow you to turn on the desired FRU identify LED, type FRU-LED-MENU on the command line.
v If an HMC is attached, it may be used to activate and deactivate a FRU identify LED. For instructions
on activating and deactivating a FRU identify LED, see the Service Focal Point chapter of the IBM
Hardware Management Console for pSeries Installation and Operations Guide, order number
SA38-0590.
Service Agent for the Model 6C3 and Model 6E3
Service support for the Model 6C3 and Model 6E3 can be enhanced through the use of the service agent
application. This application provides a number of advantages for the system user, including automatic
error reporting and analysis without customer intervention. The service agent is shipped with the system or
with the Hardware Management Console for pSeries.
Using the Service Processor and Service Agent Features
The service processor and service agent features protect users against unnecessary system downtime by
advising support personnel of any unexpected changes in the system environment. For more information
about the service processor, see Chapter 7, “Using the Service Processor,” on page 225. For more
information about the service agent application, see the IBM Hardware Management Console for pSeries
Installation and Operations Guide.
42 EserverpSeries 615 Service Guide

IBM P 615 series Specifications

General

Brand	IBM
Model	P 615 series
Category	Server
Language	English