IBM P 615 series User Manual

Drawer Release Latch Bracket (Model 6C3)
The following procedures describe the removal and replacement of the Model 6C3 drawer release latch
bracket. Before performing the following procedures, read the “Safety Notices” on page xi.
Removing a Drawer Release Latch Bracket
To remove a Model 6C3 drawer release latch bracket, do the following:
1. Place the system into the service position as described in “Placing the Model 6C3 into the Service
Position” on page 284.
2. Remove the front bezel as described in “Removing the Model 6C3 Front Bezel” on page 291.
3. Remove the retaining screws located on the front and side of the drawer release latch bracket.
4. Pull the drawer release latch bracket off of the system.
1
2
3
6
4
5
1 Model 6C3 4 Drawer Release Latch Bracket Post
2 Drawer Release Latch Bracket (Left) 5 Drawer Release Latch Bracket (Right)
3 Drawer Release Latch 6 Retaining Screws
Replacing a Drawer Release Latch Bracket
To replace a Model 6C3 drawer release latch bracket, do the following:
1. Place the system into the service position as described in “Placing the Model 6C3 into the Service
Position” on page 284.
2. Align the drawer release latch bracket posts with the holes in the system. Push the drawer release
latch bracket into place on the side of the system.
3. Secure the drawer release latch bracket into place with two retaining screws.
4. Replace the front bezel as described in “Replacing the Model 6C3 Front Bezel” on page 291.
5. Return the system to the operating position as described in “Returning the Model 6C3 to the Operating
Position” on page 285.
Chapter 9. Removal and Replacement Procedures 287

IBM P 615 series Specifications

General

Brand	IBM
Model	P 615 series
Category	Server
Language	English