IBM P 615 series User Manual

3. Pull the operator panel power cable out of the system.
Replacing the Operator Panel Power Cable
To replace the operator panel power cable, do the following:
1. Place the operator panel power cable into the system. If you are servicing the Model 6E3, note how
the operator panel power cable is routed through the system chassis.
2. Connect the the operator panel power cable to the media bay.
3. Replace the operator panel as described in “Replacing the Operator Panel” on page 343.
344 EserverpSeries 615 Service Guide

IBM P 615 series Specifications

General

Brand	IBM
Model	P 615 series
Category	Server
Language	English