IBM P 615 series User Manual

Table 9. Common Firmware Error Codes (continued)
Error Code Description Action/
Possible Failing FRU
B1xx 4602 Hardware failure
1. Was this error code logged just after the
system crashed?
NO Go to step 3.
Yes
Go to step 2.
2.
Examine the service processor error log.
Look for a 4xxx yyyy error that calls out
FRU(s) in the CEC whose timestamp just
precedes the B1xx 4602 error. If a 4xxx yyyy
error occurred, replace the FRU indicated by
the location code. If there is no 4xxx yyyy
error whose timestamp just precedes the
B1xx 4602 error, continue to step 3.
3.
a. Reboot the system in slow mode to the
SMS menus. See “Performing Slow Boot”
on page 159.
b. Examine the service processor error
logs. Look for a 4xxx yyyy error that
occurred during the slow boot that calls
out FRU(s) in the CEC.
c. If a 4xxx yyyy error occurred during the
slow boot, replace the FRU(s) indicated
by the location code(s).
d. If a 4xxx yyyy error did not occur during
the slow boot, replace:
v the service processor
Location: U0.1-P1-X1.
v the system planar
Location: U0.1-P1.
B1xx 4603 Service processor firmware corrupted
1. Reload system firmware
2. Service processor
Location:
U0.1-P1-X1
B1xx 4606 Firmware failure
1. Check for system firmware updates
2. Operator panel
Location: U0.1-L1
3. Service processor
Location: U0.1-P1-X1
B1xx 4608 Service processor early termination
1. Reset the system by disconnecting and
reconnecting system power
2. Reload system firmware
3. Service processor
Location: U0.1-P1-X1
B1xx 460A TOD clock has been reset
1. Set TOD clock
2. Service processor
Location: U0.1-P1-X1
B1xx 460B TOD battery failure TOD battery
Location: U0.1-P1-X1-V4
Chapter 5. Error Code to FRU Index 203

IBM P 615 series Specifications

General

Brand	IBM
Model	P 615 series
Category	Server
Language	English