IBM P 615 series User Manual

2 PCI Adapters 5 Light-Pipe Plate
3 Fan Tray 6 Adapter Slot Shields
11. Rotate the adapter locking latch counterclockwise, as shown in the following illustration.
12. Lift the black tab attached to the adapter retainer assembly, and keep the black tab in a vertical
position.
1
2
3
6
4
5
7
1 Model 6C3 or Model 6E3 5 PCI adapter faceplate (dotted lines)
2 Adapter Retainer Assembly 6 Adapter Retainer Assembly (in the unlocked
position)
3 Adapter Retainer Assembly (retainer seat
down and the locking latch in the locked
position)
7 PCI Adapter
4 Adapter Retainer Assembly (retainer seat
down and the locking latch in the unlocked
position)
13. Carefully grasp the PCI adapter by its top edge or upper corners, and remove it from the system.
Store the adapter in a safe place.
14. If you are removing a PCI adapter as part of another procedure, return to that procedure. If not,
continue to the next step.
15. If you do not plan to install another adapter into the vacated slot, seal the adapter slot using an
adapter-slot cover. If you are installing another adapter, go to “Replacing or Installing a
Non-Hot-Pluggable PCI Adapter” on page 296.
16. If you have other options to install, refer to the procedures for that option. If you do not have other
options to install, continue to the next step.
17. Connect the adapter cables.
Chapter 9. Removal and Replacement Procedures 295

IBM P 615 series Specifications

General

Brand	IBM
Model	P 615 series
Category	Server
Language	English