IBM P 615 series User Manual

Note: Care should be taken when replacing the system backplane. Ensure that you hold the
backplane by the attached mylar handles.
6. Replace the thumbscrew that secures the system backplane to the system chassis.
7. Replace the power supply bay chassis bracket. Insert and tighten the 7 hex-head screws.
8. Replace the the voltage regulator modules as described in “Replacing Voltage Regulator Modules” on
page 359.
9. Replace the memory DIMMs as described in “Replacing or Installing Memory DIMMs” on page 355.
10. Replace the disk drive backplane as described in “Replacing the Disk Drive Backplane or Filler” on
page 340.
11. Replace the fan tray as described in “Replacing the Fan Tray Assembly” on page 323.
12. Replace the disk drives as described in “Hot-Swap Disk Drives” on page 333.
13. Replace the media bay chassis as described in “Replacing the Media Bay Chassis” on page 346.
14. Replace the service processor assembly as described in “Service Processor Assembly” on page 312.
15. Replace both power supplies, if two were present in the system, or replace the power supply and filler
as described in “Replacing a Power Supply with the System Power Off” on page 351.
16. Replace the PCI adapter dividers as described in “Replacing a PCI Adapter Divider” on page 310.
17. Replace the PCI adapters.
18. Replace the service access cover, as described in “Replacing the Model 6C3 Service Access Cover”
on page 288.
19. Return the system to the operating position as described in “Returning the Model 6C3 to the
Operating Position” on page 285 or “Placing the Model 6E3 into the Service and Operating Position”
on page 286.
20. Reconnect all signal and power cables to the rear of the system.
21. Reconnect the power source to the system.
22. Start the system as described in “Starting the System” on page 283.
23. If you are running AIX, the bootlist command may need to be run while logged in as root user. This
rebuilds the customized boot list. Internet protocol (IP) parameters may also need to be reentered.
24. Check the firmware level on the new backplane; see “Determining the Level of Firmware on the
System” on page 253. If the firmware is down-level, down load the latest firmware from CORE or the
Web (See “System Firmware Updates” on page 252).
25. Work with the system administrator to ensure that passwords, time, date, and service processor
settings are restored.
Chapter 9. Removal and Replacement Procedures 363

IBM P 615 series Specifications

General

Brand	IBM
Model	P 615 series
Category	Server
Language	English