IBM P 615 series User Manual

5. Slide the system drawer in and out of the rack two or three times. This action aligns the system drawer
to the rails. The system drawer should glide on the rails.
6. Push the system drawer back into the rack. Using a screwdriver or similar tool, tighten the two rear
retaining screws that secure the slide rails to the rack’s rear flange.
7. Slide the system drawer about halfway out of the rack.
8. Using a screwdriver or similar tool, tighten the front four retaining screws that secure the slide rails to
the rack’s front flange.
Note:
After the system rails are installed, do not extend them past their safety latches. The safety
release latches stop the rails from overextending and separating. This action prevents the
system drawer from being accidentally pulled out too far and dropped.
Attention: If any binding is detected, loosen the six rail-retaining screws (front and rear), and repeat
substeps 4 through 7.
9. For additional stability needed when transporting the rack, fasten the system drawer to the rack
enclosure by inserting the two system-retaining thumbscrews through the bezel and chassis bracket,
and screwing them into the rack flange.
1
2
3
4
1 Model 6C3 Front Bezel
2 System-Retaining Thumbscrews for System Drawer Transport
416 EserverpSeries 615 Service Guide

IBM P 615 series Specifications

General

Brand	IBM
Model	P 615 series
Category	Server
Language	English