IBM P 615 series User Manual

Specifications continued from the previous page.
L
WAd
6.0 bels 5.9 bels
<L
pA
>
m
42 dBA 41 dBA
Model 6C3 Noise Emissions⁴ Operating Idle
L
WAd
6.1 bels 6.0 bels
<L
pA
>
m
44 dBA 43 dBA
Install/Air Flow Maintenance of proper service clearance should allow proper airflow.
Service When installing a rack unit, refer to “System Service Clearances” on page
405 for the rack correct clearances.
1. Inrush currents occur only at initial application of power, no inrush occurs during normal power off-on cycle.
2. The upper limit of the dry bulb temperature must be derated 1 degree C per 137 m (450 ft.) above 915 m (3000
ft.).
3. The upper limit of the wet bulb temperature must be derated 1 degree C per 274 m (900 ft. ) above 305 m (1000
ft.).
4. Levels are for a single system installed in a T00 32-EIA rack with the center of the unit approximately 1500 mm
(59 in.) off the floor.
Chapter 1. Reference Information 35

IBM P 615 series Specifications

General

Brand	IBM
Model	P 615 series
Category	Server
Language	English