3. Insert the display panel assembly until it clicks into position.
4. Replace the top cover, as described in “Installing or replacing the top cover:
2076-92F” on page 68.
5. Ensure the LEDs on the display panel are lit correctly. See “Storwize V7000
2076-92F expansion enclosure LEDs and indicators” on page 131 for details.
Removing the support rails: 2076-92F
You can remove the support rails for the 2076-92F expansion enclosure.
About this task
This task assumes the following conditions have been met:
v The cable management arm has been removed, as described in “Removing or
moving the cable-management arm: 2076-92F” on page 58.
v The expansion enclosure has been removed from the rack, as described in
“Removing an expansion enclosure from a rack: 2076-92F” on page 92.
Procedure
1. Remove the two screws that attach the outer rail section to the front bracket
assembly, as shown in Figure 112.
2. Remove the rail section by pulling it away from the front bracket, as shown in
Figure 112.
3. Remove the two screws that attach the inner rail section to the rear bracket, as
shown in Figure 113 on page 124.
Figure 111. Installing the display panel assembly
Figure 112. Remove the rail assembly from the front frame bracket
Chapter 2. Installing the Storwize V7000 Gen2 and Storwize V7000 Gen2+ hardware 123
To Next Page
Loading...
Need help?
General