▌1▐ Enclosure
▌2▐ Top of shipping box, folded back
▌3▐ Foam protectors
4. Remove the top cover, as described in “Removing the top cover: 2076-92F” on
page 44.
5. With two or more persons, push the expansion enclosure sideways onto an
adjacent flat bed lift. Keep the remaining foam block protectors attached to the
enclosure.
6. Remove the support rail kit from the box in which it was shipped (▌1▐, as
shown in Figure 29 on page 42).
7. Separate the inner section of the support rails and attach them to each side of
the expansion enclosure, as described in steps 3 on page 46 through 5 on page
47 in “Installing or replacing the support rails: 2076-92F” on page 46.
8. Attach the remaining sections of the support rails to the rack, as described in
step 6 on page 48 in “Installing or replacing the support rails: 2076-92F” on
page 46.
9. Move the mechanical lift to the front of the rack. Align the inner section of the
rails with the mid section of the rails that are extending from the rack.
10. On each side, push the inner section and middle section of the rails together
until they click and will no longer separate, as described in step 1 on page 55
in “Installing or replacing an expansion enclosure in a rack: 2076-92F” on page
49.
11. Remove the 4U and 1U fascia from the boxes in which they were shipped, as
shown in Figure 31 on page 44.
Figure 30. Packaging materials
Chapter 2. Installing the Storwize V7000 Gen2 and Storwize V7000 Gen2+ hardware 43
To Next Page
Loading...
Need help?
General