2. Remove the parts from the shipping container.
3. Install the enclosure in the rack by using the provided support rails.
4. Install the fascia.
5. Install the drives.
6. Install the cable management arm.
7. Connect the SAS expansion enclosures to the system.
Safety notices and considerations: 2076-92F
Before you install, service, or move the 2076-92F expansion enclosure, you must
review and follow the safety notices.
Always read and following the following safety notices and guidelines for the
2076-92F expansion enclosure.
Safety notices
Use the reference numbers in parentheses at the end of each notice (for example,
D005) to find the matching translated notice in IBM Storwize V7000 Safety Notices.
DANGER
DANGER: Serious injury or death can occur if loaded lift tool falls over or if
a heavy load falls off the lift tool. Always completely lower the lift tool load
plate and properly secure the load on the lift tool before moving or using the
lift tool to lift or move an object. (D010)
DANGER
Multiple power cords. The product might be equipped with multiple power
cords. To remove all hazardous voltages, disconnect all power cords. (L003)
DANGER
Hazardous voltage present. Voltages present constitute a shock hazard, which
can cause severe injury or death. (L004)
Chapter 2. Installing the Storwize V7000 Gen2 and Storwize V7000 Gen2+ hardware 27
To Next Page
Loading...
Need help?
General