v To support the 2076-92F expansion enclosure, a Storwize V7000 Gen2 or
Storwize V7000 Gen2+ system requires software version 7.8.0. If software version
7.8.0 is not installed on the system, do not connect or power on the expansion
enclosure.
v Before you connect the power cables to the rear of the enclosure, always check
that the expansion enclosure is secured in the rack. If needed, tighten the
thumbscrews on the front of the enclosure (▌2▐ in Figure 117) to ensure that the
enclosure drawer does not roll open.
About this task
The 2076-92F expansion enclosure has two power supply units (PSUs) that are
accessible from the front of the enclosure (▌4▐ in Figure 117). As the figure also
shows, the PSUs are covered by the 1U fascia (▌5▐).
▌1▐ Display panel LEDs
▌2▐ Rack retention thumb screws
▌3▐ Power supply unit LEDs
▌4▐ Power supply units (PSUs)
▌5▐ PSU fascia (1U)
▌6▐ Front fascia (4U)
Each PSU has a power supply connector and power cable, which are accessible
from the back of the enclosure, as shown in Figure 118 on page 129. Power is
provided by plugging a C19-C20 power cable into each power supply unit and, if
necessary, turning on the power source. The expansion enclosure does not have a
power button.
Procedure
1. Connect the C19-C20 power cables to the power connectors on the rear of the
expansion enclosure. The enclosure automatically powers on and begins its
Power On Self-Tests (POST).
Figure 117. Features on the front of the 2076-92F expansion enclosure
128 Storwize V7000 Gen2 and Gen2+: Quick Installation Guide
To Next Page
Loading...
Need help?
General