8
2
BASIC OPERATION
■ Direct frequency setting
mode operation
The direct frequency setting mode operation is useful when
setting the desired frequency directly to the active frequency
indicator.
q Push and hold [↔] for 2 sec. to enter the direct frequency
setting mode.
• The only active frequency is displayed.
w Select an operating frequency.
• Refer to pgs. 5–6 in details.
e Push [RCL] or [↔] to exit the direct frequency setting
mode.
■ Dualwatch operation
The dualwatch operation monitors active and standby fre-
quencies alternately. Therefore, it’s useful to monitor the
standby frequency while receiving the active frequency.
q Push [DUAL] to enter dualwatch operation.
• “DUAL” appears on the active frequency indicator.
• The active or standby frequency‘s “RX”blinks when receiving sig-
nal or opening the squelch.
w Push [DUAL] again to exit dualwatch operation.
• “DUAL” disappears.
• You may also exit dualwatch by pushing [PTT].
To Next Page
Loading...
Need help?
General
