13
3
CONVENTIONAL OPERATION
■ Call procedure
When your system employs tone signalling (excluding CTCSS and
DTCS), the call procedure may be necessary prior to voice trans-
mission. The tone signalling employed may be a selective calling
system which allows you to call specific station(s) only and prevent
unwanted stations from contacting you.
q Select the desired TX code channel or 2/5-tone code according
to your System Operator’s instructions.
• This may not be necessary depending on programming.
• Refer to pgs. 15, 16 for selection.
w Push the call switch (assigned to one of the dealer programma-
ble switches: [P0], [P1], [P2], [P3], [Red], []and []).
e After transmitting a 2/5-tone code, the remainder of your com-
munication can be carried out in the normal fashion.
Selective calling
Non-selective calling
IC-F50_F60_MDC-2.qxd 06.11.17 4:39 PM Page 13 (1,1)
To Next Page
Loading...
Need help?
General
