18
3
CONVENTIONAL OPERATION
3
■ User set mode
User set mode is accessed at power ON and allows you to set
seldom-changed settings. In this case you can “customize” trans-
ceiver operation to suit your preferences and operating style.
Entering the user set mode:
q While pushing and holding [ ] and [ ], rotate [VOL] to enter
the user set mode at power ON.
w Push and hold [P0] to enter user set mode. Push [P0] momen-
tarily to select the item.
Then push [ ] and [ ] to set the desired level/condition.
Available set mode functions:
• Backlight : ON, Auto or OFF
• Beep : ON or OFF
• SQL Level : 0 to 255
• AF Min level : ON or OFF
• Mic Gain : 1 to 5
• Battery Voltage : ON or OFF
e Push and hold [P0] again to exit set mode.
User set mode is also available using a programmable key. Please
refer to p. 11 [User Set Mode] section.
IC-F50_F60_MDC-2.qxd 06.11.17 4:39 PM Page 18 (1,1)
To Next Page
Loading...
Need help?
General
