Icom ID-51A Basic Instructions

45
6
D-STAR OPERATION
New2001 New2001
WaystoCommunicatewiththeDRfunction ■
With the DR function, the transceiver has three ways to communicate, as shown below.
NOTE:
•UsingtherepeaterlistisrequiredtousetheDR
function. (p. 68)
•Beforeoperatingintheduplexmode,besureto
check whether the repeater is busy, or not. If the
repeater is busy, wait until it is clear, or ask for a
“break” using a method acceptable to your local
procedures.
•ThetransceiverhasaTime-OutTimerfunction
for DV operation. The timer limits a continuous
transmission. Warning beeps will sound approx-
imately 30 seconds before time-out and then
again immediately before time-out.
INTERNET
Localareacall
Access repeater
Hamacho
repeater
Hamacho area
INTERNET
Gatewaycall
Hirano
repeater
Sapporo
repeater
Hirano area Sapporo area
To call through your local area (access) repeater.
To call through your local area (access) repeater, repeater gateway and
the internet to your destination repeater or individual station’s last used
repeater, using call sign routing.
Simplexcall
To call another station not using a repeater.

Icom ID-51A Specifications

General

Brand	Icom
Model	ID-51A
Category	Transceiver
Language	English