Icom ID-51A - Making a Simplex Call

New2001
46
6
D-STAR OPERATION
6
■ MakingaSimplexcall
You can make a transceiver to transceiver call (through no
repeater) in the DR screen.
NOTE: Depending on the transceiver's version, the fre-
quencies may be different. Check for acceptable frequen-
cies for your operating area.
WhatisaSimplexCall? ✓
A simplex call is a direct call to another station, not using a
repeater.
Hold down q
for 1 sec-
ond.
Push D-pad( w ) to select
“FROM,” and then push
D-pad(Ent).
D-pad
(�)
(Ent)
Push D-pad( e ) to select “Re-
peater List,” and then push
D-pad(Ent).
Go to step e
Example: Making a simplex call on 433.450 MHz.
“FROM”(Simplexchannel)setting1.
Push D-pad( r ) to select “20:
Simplex,” and then push D-
pad(Ent).
Push D-pad( t ) to select
“433.450,” and then push
D-pad(Ent).
 •“433.450” is displayed in
“FROM.”
 •“CQCQCQ”isdisplayedin“TO.”
- If a station call sign is set in
“TO”,select“LocalCQ”inthe
TO SELECT screen to set
“TO”to“CQCQCQ.”
D-STAR OPERATION