7.
Unscrew the NATO outlet cover.
8.
Inspect and remove any debris from the outlet.
9.
Plug the
Removable Rear Winch’s power cable into the
outlet.
Reverse the steps to dismount the Removable Rear Winch,
ensuring the winch isolation circuit (labeled EXT4) is switched o
on the Overhead Control Panel before handling the NATO wiring
connector.
After dismounting, stow the Removable Rear Winch safely before
driving your Grenadier. It must be properly secured with straps or
another appropriate tie-down system. Store the winch as low as
possible in your Grenadier and make sure that there is no
movement when the Winch is secured.
WARNING: Failure to follow these instructions and
precautions could result in serious injury and death.
REMOTE CONTROL
Overview
Each
winch
is controlled with a battery-operated wireless remote
control with three buttons and a signal lamp.
FCC Notice
FCC notice
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) This device must accept any
interference received, including interference that may cause
undesired operation.
WINCHES
164
To Next Page
Loading...
Need help?
General