Functions and Features
4.2 System-Related Operations
Though not directly related to output programming, the following functions also
control instrument operation.
4.2.1 Set the Key Beeper
You can customize the on/off setting of the sound of the keys on the front panel
of the instrument according to your needs.
The procedures to set the key beeper are as follows.
1. Press [Shift]+[Display] (System) to enter into the system menu interface.
The first displayed menu item Beep is to set the key beeper.
2. Press [Enter] key and the parameter is in modification.
3. Rotate the knob to adjust the value.
• On: default value, indicates the key sound beeper is on.
• Off: indicates the key sound beeper is off.
4. Press [Enter] key to confirm.
At this point, the key sound beeper status immediately becomes valid.
4.2.2 Set the Power-on State
This menu item is used to control the settings and output state when the power
supply is powered on.
The detailed power-on parameters and output state are as follows.
• The voltage and current setting values displayed on the main screen.
• The output state of the power supply, i.e., the [On/Off] key state.
The procedures to set the menu item are as follows.
1. Press [Shift]+[Display] (System) to enter into the system menu interface.
2. Use left and right keys or rotate the knob to select PowerOn and press
[Enter] key to make the parameter in modification.
3. Rotate the knob to select the value from the following options.
• Reset: default value, indicates when the power supply is powered on,
the power supply will initialize some settings and output state.
Copyright © Itech Electronic Co., Ltd.
48
To Next Page
Loading...
Need help?
General
