To Next Page

To Previous Page

Functions and Features

4.7 List Function

The user can use list function to create a test program made of multiple steps.

Up to 10 programs (List1 to List10) can be created in the list mode for this series

power supplies. Each list program can be made of up to 100 steps. The user

need to set voltage or current, slope and dwell time for each step. The user also

can set repeat times, end state and so on for each list program.

In the channel combination mode Combine, the List function is

unavailable.

The descriptions of list function menu are listed in the table below.

List Mode List mode

Run List Turn the list mode on/off.

On Turn the list mode on.

Off Turn the list mode off.

Apply

Channel

Select channel as CH1 or CH2

Recall List

Select a list program to view.

List Setup View the setting parameters of the selected list

program.

View Step Select the desired step to view.

Edit List

Edit list program.

List Setup Set the list program.

Mode Set the operation mode for list program.

• CC: current mode;

• CV: voltage mode.

End State Set the running state after the list pro-

gram is running over.

• Normal: keep outputting the voltage

and current setting in main interface

when the dwell time is over.

• Last: keep outputting the last step

when the dwell time is over.

Repeat Set the number of loops to run the List

file, range: 1–65535. Set to 65535 to run

in an infinite loop.

Edit Step Edit parameters for each step.

ITech IT-M3131D User Manual

Questions and Answers: